Duy's Oven
Smoker with precise air flow and temperature control for both hot and cold smoking.
The Offset 9045 is the same offset type as the Offset 10050, so it uses the same steps. The clip and the steps below are built on the 10050.
Texas-style rub: coarse sea salt and coarsely ground black pepper, 1:1. Set the smoker outdoors in an airy spot away from anything flammable, with the firebox end facing away from the wind.
Light the mangrove charcoal until it glows evenly; never use petrol or oil. The 10050 takes about 4 kg; the amounts of charcoal and wood go up or down with the size of the firebox. Open the air vent 100% at first and lay oak on the coal bed.
Wait until the smoker holds steady at 110 to 135 °C, with 121 °C as the standard mark, before putting the meat in. Adjust the heat with the firebox air vent and keep the chimney open for the whole cook.
Good smoke is thin, slightly blue and almost invisible. Thick, billowing white smoke means the fire lacks oxygen: open the air vent more, do not choke the chimney damper. Add oak one log at a time, about every 45 to 60 minutes, while the coals are still red.
The end next to the firebox runs hotter than the far end, so rotate the meat mid-cook. Opening the lid drops the needle; do not pile on charcoal when you see it fall.
At around 68 to 77 °C the core stalls for hours: do not raise the fire, just wait or wrap in butcher paper. Core temperature decides: brisket about 96 °C, beef ribs about 93 °C, pork ribs about 91 °C.
Take the meat out, wrap it loosely and let it rest 30 to 60 minutes before slicing across the grain.
Take still-glowing coals outdoors and let them burn out completely. Scrape the grates while still warm, empty the ash and grease, scrape the grease off the chamber floor. Once cool, wipe with a damp cloth and brush a thin layer of cooking oil on the grates.
Safety: burning charcoal gives off CO gas. Only run the smoker in a well-ventilated place, never in a closed room. Do not leave charcoal smouldering indoors overnight.
Figures taken straight from the workshop's records, updated whenever the build changes.